Welcome to the Real Flame family of gel fuel products. If you have questions please call customer service at
Model # G8700 Frisco Fireplace Instructions
1.Fireplace is designed to be used with Real Flame® gel fuel only. Do not use with any other gel fuel or any other flammable liquid or gel.
2.Read entire label and instructions before using Real Flame gel fuel.
3.Make sure fireplace is set on a flat, level and stable surface. Keep fireplace stable at all times.
4.Make sure fireplace and gel fuel are burned on a flat and level surface.
5.Never leave a burning fire unattended, especially around children or pets.
6.Fireplace is not to be operated by children. Keep away from children and pets.
7.Exercise the same precautions as you would with any open fire.
8.When in use some surfaces will be hot, use caution.
9.Never touch logs, gel fuel cans or any other metal surfaces during or immediately after burning gel fuel. They will be extremely HOT. Allow them to cool for 60 minutes before touching.
10.Do not burn more than three cans of fuel at once.
11.Do not place more than 15 lbs. of weight on the top of the fireplace at anytime.
12.Do not alter fireplace, metal firebox or log set in any manner.
13.Keep fireplace and gel fuel cans away from flammable materials at all times.
14.Do not store or use gasoline or any other flammable vapors, liquids, or materials in the vicinity of fireplace and gel fuel.
15.Do not wear flammable or loose clothing when operating the fireplace.
16.Do not move fireplace while in use. Do not attempt to move or store the fireplace until 60 minutes after gel fuel cans have been extinguished.
17.Do not burn trash, paper, or wood in the fireplace. Burn only Real Flame® gel fuel in the fireplace.
18.Do not burn gel fuel outside designated burn areas on the metal grate.
19.Do not put fireplace in an area with lots of traffic, such as a hallway or entryway.
20.In case of an emergency use a CO2 extinguisher to extinguish the fire.
21.Death, serious injury or damage to property may occur if the warnings above are not followed.
22.If for any reason you cannot follow these warnings please call us at
NOTICE: Buyer assumes all responsibility for safety and use that is not in accordance with instructions and warnings.
Using your Fireplace
-Fireplace is designed to be used indoors, there is no need for ventilation.
-Use extreme caution while burning. Some surfaces become extremely hot during use.
-Follow all instructions included with gel fuel before use.
-Before using fireplace, be sure you have read and understand the
-During the initial burn you may experience a slight odor. Odor is temporary and will be absent on following burns.
Step Two
-Place Left Firebox Trim (8) against two mounting blocks on the rear of Left trim Panel. Attach with three 1” screws through holes in trim.
-Repeat with Right Firebox Trim (9).
-Place the Lower Firebox Trim (11) on the base and t between the Left and Right Firebox trim pieces. Attach with four 1” screws.
-Set the Upper Firebox Trim (10) on top of the Left and Right Firebox Trim pieces and between mounting blocks. Attach to the rear of Front Trim Panels and to the rear of Left and Right Firebox Trim through mounting blocks with six 1” screws.
Step Three
-From the top, slide the Center Panel (6) down until the top edge of the Center Panel is ush with the top edge of the Front Panels. Attach with four 1“ screws through the mounting blocks and three 1” screws through the Upper Firebox Trim.
-Fit one side of the rebox support into the hole on the Right Side Panel. Slide the opposite end into the groove on the Left Side Panel. Make sure this piece is fully seated into position.
-Set the Mantel Top on top of the Front Panels and Side Panels so that the trim on the top overhangs the front and sides. Attach with six 1“ screws through Side and Front Panels. Use three 1” screws to attach Center Panel to Mantel Top.
You are now ready for the firebox installation.
Please refer to the instructions that are included with your firebox.
Gel Fireplaces - Traditional
